How To Copy Your New Remote Control On Original Remote Control

- Apr 01, 2020-

Generally we buy some brand remote controls and after some time,we think it is not beautiful or we don't like it,or we have new family members who need the new remote controls.We can offer you new remote control which can copy 280-870mhz fixed code and rolling code remote controls including most famous brands,like FAAC,BFT,GENIUS,V2,liftmaster,merik,merlin,genie,linear ,Dea,ditec,etc.i will introduce you how to copy the original remote control :

WeChat Image_201807211559111

FIXED CODE DUPLICATING PROCEDURES:

1.While pressing the button 1 of the remote, press 4 times the button 2.

2.Release both buttons. Now the led of the remote  emits a quick flash every 2 sec.

3.Place the original remote control in front of the remote , at about 2-3 cm of distance (as shown in the picture below).

4.Press and retain pressing  the button of the original remote control that you want to copy until the remote's led will change frequency of flashing (faster than before), as confirm of the correct copy of the code.

5.While the LED is flashing, press the button of the JH-TX162 where you want to store ,the remote'code just copied, until the led will turn off.

6.The copy has happened with success, verify on the automation the orderly functioning of the new  remote control.

Note:

•If the LED will flash only 3 times and then will turn off, it means that the code hasn‘t been copied well. In this case repeat the operation from the point 1.

•The memory of the  remote is completely re-writable.

•To duplicate a second button, repeat the operation from the point 1.


ROLLING SIMPLE DUPLICATING PROCEDURES

1.While pressing the button 1 of the remote , press 4 times the button 2.

2.Release both buttons. Now the led of the remote  emits a quick flash every 2 sec.

3.Place the original remote control in front of the remote , at about 2-3 cm of distance

4.Press and retain pressing the button of the original remote control that you want to copy until the remote's led will change frequency of flashing (faster than before), as confirm of the correct copy of the code.

5.While the LED is flashing, press the button of the JH-TX162 where you want to store, the remote'code just copied, until the led will turn off.

6. The copy has happened with success.

7.Proceed with the remote control recognition on the receiver by  AMC  the  procedure or follow the producer's methods