How To Program Garage Door Operator Keypad

- Jul 07, 2020-

How To Program Garage Door Operator Keypad

A: Factory default:

Default factory administrator password is 9999.

 

MegaCode 1997-Current 318MHZ:1111

Orange Button 1993-1996 390MHZ :2222

Purple Button 1993-1996 315MHZ :3333

Green Button 1993-1996 390MHZ :4444

Intellicode 2005-Current 315MHZ: 5555

Intellicode 2005-Current 390MHZ: 6666

Yellow Button 2011-Current(310/315/390MHZ):7777

B :set password:Default factory administrator code

A:Enter initial password ,hold B+9999 into edition ,key pad red LED will flash 2 times and constantly lights on , and also rings 2 times.

Next , Press button 1+B ,keypad red LED will flash 2 times then lights on constantly and keypad will ring 2 times . Enter 4 digits (0-9) administrator password which you want to set and press button B to finish , red LED will flash two times ,and enter 4 digits (0-9) administrator password again which you set at the beginning and press button B to finish . Then red LED will flash 2 times,and ring 2 times and then red LED turns off,which means setting successfully.If there is

something wrong in setting,the red LED will flash 10 times,and the keypad rings 10 times.

 

C: Set passwords :Different door models password code

 

A:Initial password ,hold B+9999 into edition ,keypad red LED will flash 2 times and constantly lights on , and also rings 2 times.press X+A( X represents the corresponding remote control model, for example: 1 represents mega code 1997-Current 318MHZ:1111)


Access password changes,Enter 4 digits (0-9) administrator password which you want set and press button B to finish , red LED will flash two times,and enter 4 digits (0-9) administrator password again which you set at the beginning and press button B to finish . Then red LED will flash 2 times,and ring 2 times and then red LED turns off,which means setting successfully.If there is something wrong in setting,the red LED will flash 10 times,and the keypad rings 10 times.

For example:Set the password for MegaCode 1997-current 318MHZ


Enter B+ administrator password (default 9999),keypad red LED will flash 2 times and constantly light on , and also rings 2 times.press 7+A,,keypad red LED will flash 2 times and constantly light on , and also rings 2 times.enter 4 digits (0-9) administrator password again which you set at the beginning and press button B to finish . Then red LED will flash 2 times,and ring 2 times and then red LED turns off,which means setting successfully.If there is something wrong in setting,the red LED will flash 10 times,and the keypad rings 10 times.

 

D :Reset password

When the administrator password or the door password is forgotten, please open the KEYPAD, remove the battery, press and hold down the A button, and install the battery at the same time.  Until hearing the ring repeatedly, it means that the password has been reset. The factory default administrator password and the keypad  password are reset.

 

 

Notes:

Generally press any keypad button, the keypad will have a prompt beep sound.

If the password is correct, green LED will flash quickly and the keypad will ring once.

If the password is incorrectly,red LED will flash 3 times,and the keypad will ring 3 times.